New Updated Cisco CCNP 642-902 Real Exam Download 291-300



Refer to the Exhibit. Routers in the Diagram are configured with EIGRP. If RTB and RTC fail, which action will RTA take with respect to the HQ network?




A.       RTA will automatically route packets via RTD to the HQ network.

B.       RTA will place the route via RTD into the hold down state.

C.       RTA will go into the active state for all routers.

D.      RTA will go into the active state for the route to HQ network.


Correct Answer: D




Refer to the exhibit. Which interoperability technique implemented on the router would allow Host-1 to communicate with Host-2?



A.  Dual Stack


C.  6to4 tunnel

D.  GRE tunnel

E.  ISATAP tunnel


Correct Answer: B




Refer to the exhibit. Which statement is true?





A.       RTA will redistribute the RIP routers into the NSSA as type 7 LSAs. RTB will translate the type 7 LSAs into type LSAs and flood them throughout the OSPF backbone.

B.       RTA will redistribute the RIP routers into the NSSA as type 7 LSAs. RTB will flood the type 7 LSAs throughout the backbone.

C.       RTA will redistribute the RIP routers into the NSSA as type 5 LSAs. RTB will flood the type 5 LSAs throughout the backbone.

D.       RTA will redistribute the RIP routers into the NSSA as type 5 LSAs. RTB will translate the type of 5 LSAs unto type 7 LSAs and flood them throughout the OSPF backbone.

E.        RTA will not redistribute the RIP routers into the NSSA.


Correct Answer: A



QUESTION 294 is a small IT corporation that is attempting to implement the network shown in the exhibit. Currently the implementation is partially completed. OSPF has been configured on routes Chicago and New York. The S0/0 interface on Chicago and the S0/1 interface on New York are in area 0. The loopback0 on New York is in Area 1. However, they cannot ping from the serial interface of the satellite router to the loopback interface of the New York router. You have been asked to complete the implementation to allow this ping.’s corporate implementation guide line requires:


l  The OSPF process ID for all routers must be 24.

l  The routing protocol for all each interface must be enabled under the routing process.

l  The routing protocol must be enabled for each interface using the most specific wild card mask possible.

l  The serial link between Seattle and Chicago must be in OSPF area 8.

l  OSPF area 8 must not receive any inter-area or external routers.


Network information


S0/0 – link between Seattle and Chicago

Secret Password: Cisco



S0/0 – link between Chicago and New York

S0/0 – link between Chicago and New York

Secret Password: Cisco




Correct Answer:

On Seattle Router:

Router ospf 24

network area 8

area 8 stub


On Chicago Router:

Router ospf 24

area 8 stub no-summary

network area 8




You are a Network Engineer with, a small IT company. has two connections to the internet: one via a frame relay link and one via an EoMPLS link. IT policy requires that all outbound HTTP traffic use the frame relay link when it is available. All other traffic may use either link. No static or default routing is allowed.


Choose and configure the appropriate path selection feature to accomplish this task. You may use the test workstation to generate HTTP traffic to validate your solution.




Correct Answer:

1. First create the access list that catches the HTTP traffic:

R1#access-list 101 permit tcp any any eq www


2. Configure the route map that sets the next hop address to be ISP1 and permits the rest of the traffic:

R1(config)#route-map pbr permit 10

R1(config-route-map)#match ip address 101

R1(config-route-map)#set ip next-hop


R1(config)#route-map pbr permit 20


3. Apply the route-map on the interface to the server in the EIGRP Network:


R1(config)#int fa0/0

R1(config-if)#ip policy route-map pbr






The Cisco SA 500 Series Security Appliances are built specifically for businesses with less than 100 employees. What are three important benefits of this device? (Choose three)


A.       business-grade firewall

B.       premium support via SMART net

C.       site-to-site VPN for remote offices

D.      Cisco IOS software-based

E.       email security

F.        XML support


Correct Answer: ACE




For a GRE tunnel to be up between two routers, which of the following must be configured?


A.       Loopback Interface

B.       IP reachability between the loopback interfaces

C.       Dynamic Routing between routers.

D.      Tunnel interfaces must be in the same subnet.


Correct Answer: D




Refer to the topology diagram R3 is redistributing the EIGRP routers into OSPF. What will the EIGRP routes appear in the routing table of R1?




A.       O

B.       O IA

C.       O E2

D.      D

E.       D EX


Correct Answer: C




What is the benefit of deploying IPv6 in a campus network using dual stack mode?


A.       Dual Stack Mode takes advantage of IPv6 over IPv4 tunnel within a network.

B.       IPv4 and IPv6 run alongside one another and have no dependency on each other to function

C.       IPv4 and IPv6 share network resources.

D.      IPv6 can depend on existing IPv4 routing, QoS, security, and multicast policies.


Correct Answer: B




To configure 6to4 on a dual-stack edge router. Which three of the following are valid in 6to4 Tunneling configuration? (Choose three)


A.       IPv4 Tunnel IP address

B.       Tunnel mode (6to4)

C.       Tunnel Keepalives

D.      IPv4 Tunnel Destination

E.       IPv4 Tunnel Source.

F.        6to4 IPv6 address (within 2002 /16)


Correct Answer: BEF


Download Latest Complete Collection of CCNP 642-902 Real Exam ,help you to pass exam 100%.

Ensurepass Cisco Certifications Exam Questions and Answers
Ensurepass CCNP Exams Questions and Answers


You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by