New Updated Cisco CCNP 642-813 Real Exam Download 181-190

Ensurepass

QUESTION 181

Refer to the exhibit. VLAN 1 and VLAN 2 are configured on the trunked links between Switch A and Switch B. Port Fa 0/2 on Switch B is currently in a blocking state for both VLANs. What should be done to load balance VLAN traffic between Switch A and Switch B?

 

clip_image002

 

A.      Lower the port priority for VLAN 1 on port 0/1 for Switch A.

B.      Lower the port priority for VLAN 1 on port 0/2 for Switch A.

C.      Make the bridge ID of Switch B lower than the ID of Switch A.

D.      Enable HSRP on the access ports.

 

Correct Answer: B

 

 

QUESTION 182

Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the CRC value?

 

A.      VTP

B.      802.1Q

C.      DTP

D.      ISL

 

Correct Answer: B

 

 

QUESTION 183

Which three statements apply to access control of both bridged and routed traffic for VLANs?

(Choose three.)

 

A.      Router ACLs can be applied to the input and output directions of a VLAN interface.

B.      Bridged ACLs can be applied to the input and output directions of a VLAN interface.

C.      Only router ACLs can be applied to a VLAN interface.

D.      VLAN maps can be applied to a VLAN interface.

E.       VLAN maps and router ACLs can be used in combination.

 

Correct Answer: ACE

 

 

QUESTION 184

Refer to the exhibit. Which statement is true about the show running-config output?

 

clip_image004

 

A.      Sw2 is configured for switch-based authentication using RADIUS.

B.      Interface FastEthernet0/6 is configured with a SmartPort macro using RADIUS.

C.      Interface FastEthernet0/6 is configured for 802.1X Authenticated Trunking Protocol (ATP).

D.      Interface FastEthernet0/6 is configured for port-based traffic control.

E.       Interface FastEthernet0/6 is configured for port-based authentication.

 

Correct Answer: E

 

 

QUESTION 185

What is a characteristic of a VLAN map that does not contain a match clause?

 

A.      implicit deny feature at end of list

B.      implicit forward feature at end of list

C.      can only be implemented by the input direction within the VLAN

D.      can only be implemented by the output direction within the VLAN

 

Correct Answer: B

 

 

QUESTION 186

Refer to the exhibit. The show port-security interface fa0/1 command was issued on switch SW1. Given the output that was generated, which two security statement are true? (Choose two.)

 

clip_image006

 

A.      Interface FastEthernet 0/1 was configured with the switchport port-security aging command.

B.      Interface FastEthernet 0/1 was configured with the switchport port-security protect

command.

C.      Interface FastEthernet 0/1 was configured with the switchport port-security violation restrict

command.

D.      When the number of secure IP addresses reaches 10, the interface will immediately shut

down.

E.       When the number of secure MAC addresses reaches 10, packets from unknown MAC

addresses will be dropped.

 

Correct Answer: BE

 

 

QUESTION 187

What is the method used to filter traffic being bridged within a VLAN?

 

A.      Ethernet maps

B.      router ACLs

C.      VLAN maps

D.      IP ACLs

 

Correct Answer: C

 

 

QUESTION 188

What are three possible router states of HSRP routers on a LAN? (Choose three.)

 

A.      standby

B.      established

C.      active

D.      idle

E.       backup

F.       initial

 

Correct Answer: ACF

 

 

QUESTION 189

Which statement describes Virtual Router Redundancy Protocol (VRRP)?

 

A.      A VRRP group has one master and at least one standby virtual router.

B.      A VRRP group has one master and one or more backup virtual routers.

C.      A VRRP group has one active and one or more standby virtual routers.

D.      A VRRP group has one active and one backup virtual router.

 

Correct Answer: B

 

 

QUESTION 190

What three tasks will a network administrator perform to successfully configure Hot Standby

Routing Protocol (HSRP)? (Choose three.)

 

A.      Define the encapsulation type

B.      Define the standby router

C.      Define the standby IP address

D.      Enable the standby mode

E.       Enable HSRP

 

Correct Answer: BCE

 

Download Latest Complete Collection of CCNP 642-813 Real Exam ,help you to pass exam 100%.

Ensurepass Cisco Certifications Exam Questions and Answers
Ensurepass CCNP Exams Questions and Answers

HOT EXAM!

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com