New Updated CCIE Data Center 350-080 Real Exam Download 71-80



Which two statements about VACLs on Cisco Nexus 7000 Series Switches are true? (Choose two.)


A.      A single VACL can be shared across two or more VDCs.

B.      Use of VACLs requires no special license to be installed.

C.      VACLs make use of IP or MAC ACLs.

D.      Only options drop and forward are permitted.


Correct Answer: BC




Consistency checks and compatibility checks are performed before a Virtual PortChannel (vPC) is created. During a compatibility check, one vPC peer conveys configuration information to the other vPC peer in order to verify that vPC member ports can actually form a PortChannel. Which statements about a “Virtual PortChannel graceful consistent check” are true? (Choose two.)


A.      Graceful consistency check is enabled by default.

B.      When graceful consistency check is enabled, only the links on the secondary peer device are suspended.

C.      Graceful consistency check is disabled by default, so to enable this feature, use graceful consistency-check command under VPC domain configuration mode.

D.      When graceful consistency check is enabled, only the inconsistent VLANs on the secondary peer device are suspended.


Correct Answer: AB




Which attribute is used to pass the user role back to the Nexus when remote AAA is enabled?


A.      Cisco AV-pair

B.      TACACS+ or RADIUS ack frame role attribute

C.      DH-CHAP challenge attribute

D.      privilege level attribute


Correct Answer: A



Each port that is configured to use LACP has an LACP port priority. Which statements are true about LACP port priority? (Choose three.)


A.      Port priority value can be configured between 1 and 65535.

B.      A higher port priority value means a higher priority of LACP.

C.      Port priority can be configured so that specific links can be chosen as active links rather than the hot standby links within the port channel.

D.      LACP uses the port priority with the port number to form the port identifier.

E.       LACP Port priority default value should always be changed.


Correct Answer: ACD




Nexus7000# config t

Nexus700(config)# interface ethernet 2/11

Nexus700(config-if)# switchport mode private-vlan host

Nexus700(config-if)# switchport private-vlan host-association 14 50

Nexus700(config-if)# exit



What will this command sequence achieve?


A.      associate interface E2/11 to community VLANs 14 and 50

B.      associate interface E2/11 to secondary VLANs 14 and 50

C.      associate interface E2/11 to primary VLAN 50 and secondary VLAN 14

D.      associate interface E2/11 to primary VLAN 14 and secondary VLAN 50


Correct Answer: D




Which command will allow you to display the configured QoS group and the ingress buffer allocated to each QoS group?


A.      show interface priority-flow-control

B.      show interface queuing

C.      show queuing interface

D.      show policy-map system type queuing

E.       show policy-map interface ethernet <x/y> type queuing


Correct Answer: C


Refer to the exhibit. During troubleshooting of Virtual PortChannel (vPC), it is observed that Virtual PortChannel 2 is in a down state. What’s the cause of this issue?




A.      Virtual PortChannel is down because LACP is not enabled on the remote switch.

B.      Virtual PortChannel is down because of a VLAN mismatch.

C.      Virtual PortChannel is down because of an MTU mismatch.

D.      Virtual PortChannel is down because of VLAN and MTU mismatch.


Correct Answer: C





With Cisco NX-OS on a Cisco Nexus platform, which command shows memory usage, total processes, and CPU state?


A.      show memory detailed

B.      show process cpu sorted

C.      show system resources

D.      show hardware capacity


Correct Answer: C




What is the difference between the Ethanalyzer and the SPAN feature in Cisco NX-OS?


A.      The Ethanalyzer captures control-plane traffic, while SPAN captures all traffic.

B.      The Ethanalyzer captures all traffic including control-plane traffic, while SPAN captures only the control-plane traffic.

C.      The Ethanalyzer captures only data traffic, while SPAN captures all traffic.

D.      The Ethanalyzer captures only control traffic, while SPAN captures data traffic.


Correct Answer: A




Virtual PortChannels (vPCs) allow links that are physically connected to two different Cisco switches to appear to a third downstream device as coming from a single device and as part of a single port channel. Which of the following are components of a Virtual PortChannel system? (Choose four)


A.      Two peer devices: the vPC peers of which one is primary and one is secondary and are part of a vPC domain.

B.      A Layer 3 Gigabit Ethernet link called peer-keepalive link to resolve dual-active scenarios

C.      A redundant 10 Gigabit Ethernet PortChannel called a peer link to carry traffic from one system to the other when needed

D.      vPC member ports forming the PortChannel

E.       A dot1q trunk between the vPC peers

F.       A management port that can be used as peer-keepalive link to resolve dual-active scenarios.


Correct Answer: ABCD


Download Latest Complete Collection of CCIE Data Center 350-080 Real Exam,pass exam 100%.

Try CCIE Data Center 350-080 Free Demo
Ensurepass Cisco Certifications Exam Questions and Answers
Ensurepass CCIE Data Center Exams Questions and Answers



You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by