[Free] 2019(Nov) EnsurePass Cisco 400-151 Dumps with VCE and PDF 21-30

Get Full Version of the Exam
http://www.EnsurePass.com/400-151.html

Question No.21

On which two features does ITD depend? (Choose two)

  1. interface-vlan

  2. IP SLA

  3. BFD

  4. WCCP

  5. PBR

Correct Answer: BE

Question No.22

How do you manually configure a vNIC MAC address?

  1. Use the mac -address-table static command.

  2. Modify the dynamic vNIC connection policy.

  3. Use the set identity dynamic-mac command.

  4. Modify the adapter policy.

Correct Answer: D

Question No.23

Which two options are best practices when registering Cisco UCS Manager to UCS Central? (Choose two.)

  1. Use an IP address for UCS Domain when registering.

  2. Ensure that NTP is configured on the UCS Domain and UCS Central.

  3. Ensure that the UCS Domain and UCS Central are in the same Layer 2 domain.

  4. Use a fully qualified domain name for UCS Domain.

  5. Ensure that the independent local time source is used for UCS Domain and UCS Central.

Correct Answer: BD

Question No.24

Refer to the exhibit. Which statement about the displayed ACI Fabric is true?

image

  1. This fabric is configured for VMM integration

  2. The number of user-defined tenants is 26

  3. The capacity information shown is typical of multipod deployments

  4. Too many endpoints are connected to nodes 121 and 122

  5. Integrated Layer 4 Layer 7 services are not in use

Correct Answer: B

Question No.25

Which statement about FCoE NPV in Cisco NX-OS and the Cisco Nexus 5000 Series Switches is true?

  1. Connectivity from an FCoE NPV bridge to the FCF is supported over point-to-point links and when FCF is up to three hops away.

  2. The FCoE NPV does not provide any equivalent FCoE Initialization Protocol snooping capabilities

  3. FCoE NPV and NPV cannot be implemented together because these two thest feature use different mechanisms to communicate to the switch.

  4. FCoE NPV does not have the management and troubleshooting issues that are inherent to managing hosts remotely at the FCF.

    Correct Answer: D

    Question No.26

    Refer to the exhibit. When adding an ASAv to the APIC, the user notices a fault raised on the device. Which cause of this fault is the most likely?

    image

    1. The device package was never uploaded

    2. The incorrect username and password was used

    3. The configuration specified HTTP and not HTTPS

    4. The configuration did not specify quot;apicquot; as the username

Correct Answer: D

Question No.27

Refer to Exhibit. Which option is the minimum number of vNICS required by the service profile to connect to all available Vlans?

image

A.

6

B.

7

C.

3

D.

1

Correct Answer: C

Question No.28

Refer to the exhibit. Which option describes the main purpose of the XML messages?

image

  1. Shut down an existing port group profile

  2. Delete an existing port group profile

  3. Modify an existing port group profile

  4. Create a new port group profile

Correct Answer: D

Question No.29

Refer to the exhibit. An administrator must configure a SAN port channel between a cisco UCS and a MDS switch as shown in the exhibit. The UCS fabric interconnects are in FC switch mode. The administrator creates a port channel on the MDS switches with the configuration. After, which configuration change is needed to bring up the port channel?

Question No.30

Which option is a valid overlay interface configuration and configures the OTV edge device as a secondary OTV adjacency server?

  1. interface Overlay 1

    otv join-interface e 101/1/48 otv adjacency-server secondary

    otv use-adjacency-server primary 10.1.1 1 otv extend-vlan 5-10

  2. interface Overlay 1

    otv join-interface e1/2

    otv adjacency-server unicast-only

    otv use-adjacency-server 10 111 unicast-only

    otv extend-vlan 5-10

  3. interface Overlay 1

    otv join-interface e101/1/48

    otv adjacency-server unicast-only

    otv use-adjacency-server 10 1.1 1 unicast only otv extend-vlan 5-10

  4. interface Overlay 1 otv join-interface e1/2

otv use-adjacency-sen/er 10.1 1 1 10.1.1 2

otv extend-vlan 5-10

Correct Answer: B

Get Full Version of the Exam
400-151 Dumps
400-151 VCE and PDF

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com