[Free] 2019(Nov) EnsurePass Cisco 300-135 Dumps with VCE and PDF 31-40

Get Full Version of the Exam

Question No.31

Refer to exhibit. The tunnel between R2 and R5 is not coming up. R2, R4 and R5 do not have any routing information sources other than OSPF and no route filtering is implemented anywhere in the network. Which two actions fix the issue? (Choose Two)


  1. Redistribute connected routes to OSPF on R5.

  2. Change the tunnel destination on R2 to

  3. Advertise interface Lo0 to OSPF on R5.

  4. Configure a static route on R5 to via

  5. Fix the OSPF adjacency issue between R2 and r5.

Correct Answer: AC


In order for the tunnel to be established between R2-R5 ,the R2 should have a path for the route in its own routing table , and because the ospf is the only routing protocol here , so R5 has to advertise the route, and that is possible through these option:

1-redistribute connected route to ospf on R5 2-Advertise interface lo0 to OSPF on R5

For knowing more about the rules for the gre channel to be established, check the link below:

http://www.cisco.com/c/en/us/support/docs/ip/generic-routing-encapsulation-gre/118361- technote-gre-00.html

Question No.32

Refer to exhibit. After a junior technician configures a new branch office GRE tunnel, which step is missing from the configuration to pass traffic through tunnel on Router 1?


A. static route to via B. static route to via C. static route to via D. static route to via

Correct Answer: D

Question No.33

On which two topologies can you deploy a point-to-point GRE over IPsec design? (Choose two.)

  1. bus

  2. partial-mesh

  3. hub-and-spoke

  4. ring

  5. tree

Correct Answer: BC

Question No.34

Which two conditions can you use to filter the output of the debug condition command? (Choose two.)

  1. interface ID

  2. port number

  3. packet size

  4. protocol

  5. username

Correct Answer: AE

Question No.35

Refer to the exhibit. Your company security policy states you must use SSH on your network devices. Your attempt to SSH into SW3 is unsuccessful. What action must you take to correct the issue?

SW3#sho run | sec vty line vty 0 4

access-class 100 in login

transport input ssh

SW3#sho access-list Extended IP access list 100 10 deny tcp any any eq 22 20 permit ip any any Extended IP access list 150

10 permit tcp any any eq telnet 20 deny tcp any any eq 22

30 permit ip any any Extended IP access list 175 10 permit tcp any any eq 22

20 permit tcp any any eq telnet

  1. Change access-class 100 in to access-class 175 in.

  2. Change access-class 100 in to access-class 150 in.

  3. Change access-class 100 in to access-class 100 out.

  4. Change transport inut ssh to transport input telnet

Correct Answer: A

Question No.36

Which three protocols or protocol combinations does Management Plane Protection (MPP) support? (Choose three.)

  1. SFTP

  2. SSH

  3. Both HTTP and HTTPS

  4. FTP

  5. Only HTTP

  6. OSPF

Correct Answer: BCD

Question No.37

Refer to the exhibit. When troubleshooting an adjacency issue on router R1, you generated the given debug output. Which two values are mismatched between R1 and its neighbor? (Choose



  1. hello timer settings

  2. metric calculation mechanisms

  3. authentication parameters

  4. autonomous system numbers

  5. hold timer settings

Correct Answer: BD

Question No.38

You want to troubleshoot an OSPF adjacency issue. Which two tasks must you perform? (Choose two.)

  1. Issue the debug ip ospf nsf command to identity the cause.

  2. Issue the debug ip ospf adj command to identify the cause.

  3. Verify that the router IDs on the two routers match.

  4. Verify that the subnet masks on the two routers match.

  5. Verify that the process IDs on the two routers match.

Correct Answer: BD

Question No.39

Which IPsec mode encrypts a GRE tunnel and adds the least amount of overhead?

  1. tunnel

  2. transport

  3. dynamic

  4. transparent

Correct Answer: B

Question No.40

Which protocol does mGRE use to determine where packets are sent?

  1. CEF

  2. EIGRP

  3. NHRP

  4. DMVPN Correct Answer: A Explanation:

https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/41940- dmvpn.html

Get Full Version of the Exam
300-135 Dumps
300-135 VCE and PDF

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com