[Free] 2018(Mar) EnsurePass Testinsides Cisco 300-165 Dumps with VCE and PDF 61-70

Ensurepass.com : Ensure you pass the IT Exams
2018 Mar Cisco Official New Released 300-165
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco Data Center Infrastructure

Question No: 61 – (Topic 4)

Which three VDC resources can be constrained with a resource template? (Choose three.)

  1. ACLs

  2. NAT entries

  3. IPv4 routes

  4. IPv6 routes

  5. SPAN sessions

  6. RBAC users

Answer: C,D,E Explanation:

VDC resource templates set the minimum and maximum limits for shared physical device resources when you create the VDC. The Cisco NX-OS software reserves the minimum limit for the resource to the VDC. Any resources allocated to the VDC beyond the minimum are based on the maximum limit and availability on the device.

You can explicitly specify a VDC resource template, or you can use the default VDC template provided by the Cisco NX-OS software. VDC templates set limits on the following resources:

->IPv4 multicast route memory

->IPv6 multicast route memory

->IPv4 unicast route memory

->IPv6 unicast route memory

->Port channels

->Switch Port Analyzer (SPAN) sessions


->Virtual routing and forwarding instances (VRFs)

Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx- os/virtual_device_context/configuration/guide/b-7k-Cisco-Nexus-7000-Series-NX-OS- Virtual-Device-Context-Configuration-Guide/vdc-res-template.html

Question No: 62 – (Topic 4)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

Which statement based on these two outputs that were collected 24 hours apart is true?

  1. The Site 2 OTV edge device has gone down.

  2. The MAC address cannot be discovered on two separate port channel interfaces.

  3. The MAC address that ends in 020a moved to the local site 23 hours ago.

  4. The Overlay1 IP address should be a multicast IP address.

Answer: C

Topic 5, Infrastructure Storage

Question No: 63 – (Topic 5)

Which two RFCs are supported by Cisco NX-OS devices for OSPFv2? (Choose two.)

  1. RFC 2238

  2. RFC 1918

  3. RFC 1583

  4. RFC 2453

  5. RFC 2740

Answer: A,C

Question No: 64 – (Topic 5)

Which three parameters can be set when configuring a Cisco MDS 9000 Series Switch to use a TACACS server? (Choose three.)

  1. group-size

  2. deadtime

  3. timeout

  4. keep-alive

  5. retransmit

Answer: B,C,E

Question No: 65 – (Topic 5)

Which feature must be enabled for Cisco TrustSec FC Link Encryption to work on a Cisco MDS 9000 Series Switch?

  1. crypto IKE

  2. port security

  3. LDAP

  4. FC-SP

Answer: D

Question No: 66 – (Topic 5)

Which configuration is specific to Cisco TelePresence System seed devices?

  1. radius server radius-server-name

  2. aaa session-id common

  3. radius-server vsa send authentication

  4. aaa new-model

Answer: A

Question No: 67 – (Topic 5)

Which command ensures that a learned MAC address is stored within NVRAM?

  1. switchport port-security mac-address address [vlan vlan-ID]

  2. switchport port-security

  3. switchport port-security mac-address sticky

  4. feature port-security

Answer: C

Question No: 68 – (Topic 5)

How does an FCoE end node acquire its FCoE MAC address?

  1. server-provided MAC address

  2. Fibre Channel name server

  3. fabric-provided MAC address

  4. FIP proxy

Answer: C Explanation:

The VN_Port is assigned a fabric-provided Mac address (FPMA) that is built by concatenating a 24-bit FCoE MAC address prefix (FC-MAP), ranging from 0x0E-FC-00 to 0x0E-FC-FF, to the 24-bit FCID. Being able to build a unique MAC address for the VN_Port directly from its FCID saves the switch from having to maintain a table that associates FCID and MAC addresses.

Reference: http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Data_Center/UF_FCoE_final.ht ml

Question No: 69 – (Topic 5)

Which Cisco MDS feature needs to be enabled for Cisco TrustSec FC Link Encryption to work?

  1. feature FC-TSLE

  2. feature Trust-Sec

  3. feature FC-SP

  4. feature ESP

  5. feature DHCHAP

Answer: C

Question No: 70 – (Topic 5)

Which situation must you consider when you add a remote RADIUS server to a Cisco Nexus device?

  1. If RADIUS authentication fails, the device falls back to local authentication automatically.

  2. If RADIUS authentication fails, the user is denied access with no further authentication checks.

  3. If the RADIUS server is unreachable, users are unable to log in.

  4. If the RADIUS server is unreachable, all users are given access with the default role.

Answer: B

100% Ensurepass Free Download!
Download Free Demo:300-165 Demo PDF
100% Ensurepass Free Guaranteed!
300-165 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No


You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com