[Free] 2018(Mar) EnsurePass Testinsides Cisco 300-101 Dumps with VCE and PDF 191-200

Ensurepass.com : Ensure you pass the IT Exams
2018 Mar Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco IP Routing

Question No: 191 – (Topic 7)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

Which technology can be employed to automatically detect a WAN primary link failure and failover to the secondary link?

  1. HSRP

  2. VRRP

  3. IP SLA

  4. multicast

Answer: C

Question No: 192 – (Topic 7)

Various employees in the same department report to the network engineer about slowness in the network connectivity to the Internet. They are also having latency issues communicating to the network drives of various departments. Upon monitoring, the engineer finds traffic flood in the network. Which option is the problem?

  1. network outage

  2. network switching loop

  3. router configuration issue

  4. wrong proxy configured

Answer: B

Question No: 193 – (Topic 7)

Which statement is true?

  1. RADIUS uses TCP, and TACACS uses UDP.

  2. RADIUS encrypts the entire body of the packet.

  3. TACACS encrypts only the password portion of a packet.

  4. TACACS separates authentication and authorization.

Answer: D

Question No: 194 – (Topic 7)

What does the show ip route vrf CISCO command display?

  1. directly connected routes for VRF CISCO.

  2. the routing table for VRF CISCO.

  3. the global routing table.

  4. all routing tables that start with VRF CISCO.

  5. the route distinguisher for VRF CISCO

Answer: B

Question No: 195 – (Topic 7)

A network engineer enables a trunk port and encounters the following message:%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet 1/1, changed state to up. What is the severity level of this message?

  1. alert

  2. critical

  3. notification

  4. informational

Answer: C

Question No: 196 – (Topic 7)

Which statement is true about the command ipv6 ospf 1 area 0?

  1. It must be issued in router global configuration mode to enable the OSPF process for


  2. It must be issued in interface configuration mode to enable the OSPF process for IPv6.

  3. It must be issued before the network command to enable the OSPF process for IPv6.

  4. It must be issued after the network command to enable the OSPF process for IPv6.

Answer: B

Question No: 197 – (Topic 7)

Which two statements about IP access-lists are true? (Choose two)

  1. IP access-lists without at least one deny statement permit all traffic by default.

  2. Extended access-lists must include port numbers.

  3. They support wildcard masks to limit the address bits to which entries are applies.

  4. Entries are applied to traffic in the order in which they appear.

  5. They end with an implicit permit.

Answer: C,D

Question No: 198 – (Topic 7)

Which two routing protocols are supported by Easy Virtual Network? (Choose two.)

  1. RIPv2

  2. OSPFv2

  3. BGP

  4. EIGRP

  5. IS-IS

Answer: B,D

Question No: 199 – (Topic 7)

Which two statements about AAA implementation in a Cisco router are true? (Choose two.)

  1. RADIUS is more flexible than TACACS in router management.

  2. RADIUS and TACACS allow accounting of commands.

  3. RADIUS and TACACS encrypt the entire body of the packet.

  4. RADIUS and TACACS are client/server AAA protocols.

  5. Neither RADIUS nor TACACS allow for accounting of commands.

    Answer: B,D

    Question No: 200 – (Topic 7)

    Given the network diagram.

    Ensurepass 2018 PDF and VCE

    Which address would successfully summarize only the networks seen?

    A. B. C. D. E.

  6. These networks cannot be summarized.

Answer: C Explanation:

let#39;s suppose it is a /20 then we would have addresses from to Now let#39;s suppose it is a /21 then we would have addresses from to

So both summaries encompass the networks we want to summarize but the second one is the most restrictive one as it only encompasses the networks we were asked to summarize and not others so it is the correct summary.

In fact just count the number of subnets which is 8 and find the exponent of 2 which is 8, that gives you 3 and to find out the summary mask just do /24 – 3 = /21.

if you make it in binary you#39;ll find out the answer too: the interesting octet is 3rd one so let#39;s convert in binary. 8 0000 1000

9 0000 1001

10 0000 1010

11 0000 1011

12 0000 1100

13 0000 1101

14 0000 1110

15 0000 1111

I#39;ve bolded the bits in common there are 5 so 16 5=21 which is mask and address is

100% Ensurepass Free Download!
Download Free Demo:300-101 Demo PDF
100% Ensurepass Free Guaranteed!
300-101 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com