[Free] 2017(Oct) EnsurePass Pass4sure Cisco 648-247 Dumps with VCE and PDF 1-10

EnsurePass
2017 Oct Cisco Official New Released 648-247
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/648-247.html

Implementing Cisco Connected Physical Security 2 Exam (CCSP 2)

Question No: 1

When a 24 VDC fail safe lock is being used to secure a door, how should power be supplied to the lock from the control source?

  1. connected 24 VDC directly to the lock

  2. connected 24 VDC through common and normally close

  3. connected 24 VDC through common and normally open

  4. connected 5 VDC binary control signaling

Answer: B

Question No: 2

What are the three common methods that are used for authentication with an access control system?

  1. badge card, key fob, and keypad PIN

  2. badge card, keypad PIN, and password

  3. something you know, something you have, and something you are

  4. something you know, something you have, and something you did

Answer: C

Question No: 3

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

One or more expansion modules is connected to the Cisco Access Gateway via a CAN bus. How should the CAN bus wires be connected after the last module in the chain?

  1. The CAN bus wires should be looped back to the Cisco Access Gateway.

  2. The CAN bus wires should be twisted together and tucked away.

  3. The CAN bus wires should be plugged into a Layer 2 Ethernet switch.

  4. The CAN bus wires should be terminated with a high-impedance resistor.

Answer: D

Question No: 4

What are the four main components of a typical logical door?

  1. door, door knob, door jam, and hinges

  2. lock, reader, tailgate sensor, and motion detector

  3. lock, request to exit, door position switch, and swing arm

  4. lock, reader, request to exit, and door position switch

Answer: D

Question No: 5

Cisco Physical Access Manager (Cisco PAM) is an appliance-based solution. The Cisco PAM 1.3.2 appliance is available on which of the following server platforms?

  1. CIVS-MSP-1RU-K9

  2. CPS-MSP-1RU-K9

  3. CPS-MSP-2RU-K9

  4. CIAC-PAME-1125-K9

Answer: B

Question No: 6

In the event of a loss in network connectivity, what is the maximum number of credentials and events that can be cached on board the Cisco Physical Access Control Gateway

module?

  1. 25,000 credentials and 10,000 events

  2. 25,000 credentials and 15,000 events

  3. 250,000 credentials and 100,000 events

  4. 250,000 credentials and 150,000 events

Answer: D

Question No: 7

Does the Cisco Physical Access Control Gateway have the ability to power other devices?

  1. Yes, the gateway has a total of 650 milliamperes (ma) of available power for readers, locks, and other devices.

  2. Yes, the gateway can power one reader, one lock, and one additional module.

  3. Yes, the gateway uses the Eth1 port to pass PoE.

  4. No, the gateway cannot power any other devices.

Answer: A

Question No: 8

Which of the following statements are true?

Eth1 has an IP address of 192.168.1.42, and it cannot be changed.

The Cisco Access Gateway can only store one firmware version at a time. Two readers can be connected to a single Cisco Access Gateway.

Gateway inputs and outputs can be configured directly on the gateway, without the use of the Cisco Physical Access Manager software.

  1. All of the statements are true.

  2. Only Statements 1 and 3 are true.

  3. Only Statements 2 and 4 are true.

  4. Statements 2, 3, and 4 are true.

Answer: B

Question No: 9

What are the various ways to provide power to the access control reader, input, and output modules?

  1. PoE only

  2. 12 VAC only

  3. 12 to 24 VDC only

  4. PoE or 12 to 24 VDC

Answer: C

Question No: 10

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

In the event of a loss of connectivity from the Cisco Access Gateway to the expansion modules on the CAN bus, with DC power still connected, what will happen if an access card was presented to a card reader that is connected to one of the Reader Modules?

  1. Reader Module will first try to authenticate the user by attempting to contact the Cisco Access Gateway. Because connectivity is lost, Reader Module will not be able to authenticate, and no access will be granted.

  2. Reader Module will first try to authenticate the user by attempting to contact the Cisco Access Gateway. Because connectivity is lost, Reader Module will fall back to its locally cached credentials and grant access if the card is valid.

  3. Reader Module will first try to authenticate the user using its locally cached credentials.

    If the credentials are in the local database, access will be granted. If the credentials are not present, Reader Module will attempt to contact the Cisco Access Gateway, time out, and deny access to the user.

  4. Reader Module will sound an audible alarm.

Answer: A

100% Free Download!
Download Free Demo:648-247 Demo PDF
100% Pass Guaranteed!
Download 2017 EnsurePass 648-247 Full Exam PDF and VCE

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com