Conducting Cisco Unified Wireless Site Survey V2
Question No: 61
An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?
A. 50 B. 100 C. 250 D. 500 E. 1000
Question No: 62
Refer to the exhibit.
What is the most likely cause of MAP1 association to MAP2 instead of directly to the RAP?
Absorption and scattering caused by weather conditions.
Incorrect radio configuration
Question No: 63
An engineer is tasked with designing a WLAN. The customer is prioritizing data speeds to the desktop, but is also entertaining the idea of adding 802.11 phones in the future. Given this information, how should the engineer conduct the survey?
consider the employee head count in congested office space and limit the edge of each cell to an RSSI of -67mW
restrict AP cell edges to -67dB and be sure to strategically place APs in congested office spaces
co-locate access points when possible to cover high user areas and place APs at each corner of the facility
stagger the AP placements, and be sure to have a high signal to noise ratio that will accommodate the future VoIP devices
Question No: 64
When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?
Question No: 65
An engineer wants to provide coverage between warehouse shelving stocked with bulk metal materials. What antenna would be adequate for performing this survey?
5.5 dBi omni down tilt
17 dBi grid
2.2 dBi omni
8.5 dBi patch
Question No: 66
A wireless engineer is gathering equipment to perform a point-to-point bridge survey. What three pieces of equipment should be used? (Choose three.)
3502i with dual band directional antennas
3502e with AIR-ANT2460NP-R
1132 with a 10dBi Yagi
1552e with three AIR-ANT2547-N=
1552e with AIR-ANT2588P3M-N=
1310 with internal antenna
1142 Series with internal antennas
Question No: 67
Which option will allow the maximum 2.4 GHz channel usage for a survey and voice deployment in the ETSI domain?
A. 1, 6, 11
B. 1, 5, 9, 13
C. 1, 6, 9, 14
D. 1, 6, 11, 14
Question No: 68
Which two types of information should be included in the installation inventory portion of the post-installation report? (Choose two.)
All AP, controller, and MSE administrator credentials
The number and type of all WLAN clients and tags
The names, locations, IP addresses, MAC addresses, etc. for every AP, controller, and MSE in the WLAN
Results of the coverage audit performed with the site survey mapping tool
Question No: 69
Which two details are specified in the Executive Summary section of the Site Survey Report? (Choose two.)
proposed location for each AP
customer and site surveyor contact details
total number of APs
expressed requirements set by customer
Question No: 70
How many location points are needed to validate both 802.11b/g and 802.11a in the Cisco WCS Calibration?
A. 50 B. 100 C. 150 D. 200 E. 300
100% Ensurepass Free Download!
–Download Free Demo:642-732 Demo PDF
100% Ensurepass Free Guaranteed!
–Download 2017 EnsurePass 642-732 Full Exam PDF and VCE
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|