[Free] 2017(Oct) EnsurePass Testinsides Cisco 640-875 Dumps with VCE and PDF 31-40

EnsurePass
2017 Oct Cisco Official New Released 640-875
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/640-875.html

Building Cisco Service Provider Next-Generation Networks, Part 1 (SPNGN1)

Question No: 31 – (Topic 3)

Which three physical lines can provide local or remote access to a Cisco router or switch? (Choose three.)

  1. Console port

  2. Modem port

  3. Virtual terminal lines

  4. Switch fabric interface

  5. Aux port

  6. ManagementEthernet0/RSP0/CPU0/0

Answer: A,E,F

Question No: 32 – (Topic 3)

Which three statements about the ARP function are true? (Choose three.)

  1. ARP is used to determine an IP address.

  2. An ARP request is broadcast at Layer 3.

  3. An ARP response is broadcast at Layer 2.

  4. ARP tables are maintained on Layer 3 devices.

  5. The destination MAC address of an ARP request is that of the ARP responder.

  6. ARP requests are broadcast at Layer 2.

  7. ARP resolves MAC addresses to NET addresses.

  8. ARP uses 0x0806 as the Type field in an Ethernet frame.

Answer: D,F,H

Question No: 33 DRAG DROP – (Topic 3)

Exhibit:

Ensurepass 2017 PDF and VCE

Ensurepass 2017 PDF and VCE

Answer:

Ensurepass 2017 PDF and VCE

Question No: 34 – (Topic 3)

Which statement about STP operations is true?

  1. One root bridge exists per collision domain.

  2. One root port is established per root bridge.

  3. One designated port is defined per segment.

  4. Non-designated ports are set in the forwarding state.

  5. One root port exists per broadcast domain.

Answer: C

Question No: 35 DRAG DROP – (Topic 3)

Ensurepass 2017 PDF and VCE

Answer:

Ensurepass 2017 PDF and VCE

Question No: 36 – (Topic 3)

This show output is from the S7 Cisco Metro Switch and the PE7 Cisco ASR 9000 Series Router. Which configuration change(s) is/are needed to bring the S7 FastEthernet 0/2 interface into the up/up state?

S7#show cdp neighborslt;OUTPUT OMITTEDgt; Device ID Local Intrfce Holdtme Capability Platform Port IDPE7 Fas 0/2 163 R ASR9K Ser Gig 0/0/0/0S78 Fas 0/23 146 S I ME- 3400E- Fas 0/21S8 Fas 0/21 178 S I ME-3400E- Fas 0/21 *Mar 20 21:28:02.177:

%ETHCNTR-3-HALF_DUX_COLLISION_EXCEED_THRESHOLD: Collisions at

FastEthernet0/2 exceed threshold. Considered as loop-back.*Mar 20 21:28:02.177: %PM- 4-ERR_DISABLE: loopback error detected on Fa0/2, putting Fa0/2 in err-disable state*Mar 20 21:28:03.184: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to down S7#show interface fa0/2FastEthernet0/2 is down, line protocol is down (err-disabled) Hardware is Fast Ethernet, address is e8ba.70b5.6c04 (bia e8ba.70b5.6c04) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Half-duplex, 10Mb/s, media type is 10/100BaseTX input flow-control is off, output flow- control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:40, output 00:00:00, output hang never Last clearing of quot;show interfacequot; counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0

bits/sec, 0 packets/sec 484423 packets input, 39349929 bytes, 0 no buffer Received

484423 broadcasts (167203 multicasts) 0 runts, 0 giants, 0 throttles 1 input errors, 0 CRC,

0 frame, 0 overrun, 0 ignored 0 watchdog, 167203 multicast, 0 pause input 0 input packets

with dribble condition detected 972398 packets output, 128931949 bytes, 0 underruns 0

output errors, 46 collisions, 4 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out RP/0/RSP0/CPU0:PE7#show interfaces gi0/0/0/0GigabitEthernet0/0/0/0 is down, line protocol is down Interface state transitions: 4 Hardware is GigabitEthernet, address is 4055.392f.40a8 (bia 4055.392f.40a8) Internet address is 192.168.107.70/24 MTU 1514 bytes, BW 100000 Kbit (Max: 100000 Kbit) reliability 255/255, txload 0/255, rxload 0/255 Encapsulation ARPA, Full-duplex, 100Mb/s, THD, link type is force-up output flow control is off, input flow control is off loopback not set, ARP type ARPA, ARP timeout 04:00:00 Last input 00:00:00, output 00:00:35 Last clearing of quot;show interfacequot; counters never 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 972551 packets input, 128953765 bytes, 729 total input drops 172486 drops for unrecognized upper-level protocol Received 0 broadcast packets, 800781 multicast packets 0 runts, 0

giants, 0 throttles, 0 parity 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

484545 packets output, 39360900 bytes, 0 total output drops Output 317283 broadcast

packets, 167262 multicast packets 0 output errors, 0 underruns, 0 applique, 0 resets 0 output buffer failures, 0 output buffers swapped out 4 carrier transitions

  1. Enable loopback line on the S7 Fa0/2 interface then shut and no shut the Fa0/2 interface.

  2. Enable duplex half on the PE7 Gi0/0/0/0 interface then shut and no shut the Fa0/2 interface on S7.

  3. Change S7 Fa0/2 interface to duplex full and speed 100 then shut and no shut the Fa0/2 interface.

  4. Just need to no shut the Fa0/2 interface on S7.

  5. Just need to shut and no shut the Fa0/2 interface on S7.

Answer: C

Topic 4, Routed Network Technologies

Question No: 37 DRAG DROP – (Topic 4)

Ensurepass 2017 PDF and VCE

Answer:

Ensurepass 2017 PDF and VCE

Question No: 38 – (Topic 4)

The network administrator is using a Windows PC application that is called putty.exe for remote communication to a switch for network troubleshooting. Which two protocols could be used during this communication? (Choose two).

  1. SNMP

  2. HTTP

  3. Telnet

  4. RMON

  5. SSH

Answer: C,E

Question No: 39 – (Topic 4)

Which two statements about classful or classless routing protocol operations are true? (Choose two.)

  1. Classful routing protocols do not send subnet mask information with theirrouting updates.

  2. Variable-length subnet masks are supported when using classful routing protocols.

  3. Examples of classless routing protocols include RIPv1, EIGRP, OSPF, andIS-IS.

  4. Classful routing protocols do not support discontiguous subnets.

Answer: A,D

Question No: 40 – (Topic 4)

A customer uses OSPF as their Customer Edge routing protocol and remote sites are reporting 10.0.0.0/8 in the routing tables. What is most likely the mis-configuration in the redistribution?

  1. Improper route summarization on CE router

  2. Incorrect network statement

  3. Incorrect K value configured

  4. Configuration missing subnets key word

  5. Stub network is sending summarized routes

Answer: D

100% Free Download!
Download Free Demo:640-875 Demo PDF
100% Pass Guaranteed!
Download 2017 EnsurePass 640-875 Full Exam PDF and VCE

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com