200-301 Real Exam Dumps Questions and answers 61-70

Get Full Version of the Exam
http://www.EnsurePass.com/200-301.html

Question No.61

Refer to the exhibit. The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another? (Choose two.)

image

A.

Configure the ipv6 route 2012::/126 2023::1 command on the Washington router

B.

Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.

C.

Configure the Ipv6 route 2012::/126 s0/0/0 command on the Atlanta router

D.

Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router

E.

Configure the ipv6 route 2012::/126 2023::2 command on the Washington router

Correct Answer: CE

Question No.62

When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?

A.

The floating static route must have a higher administrative distance than the primary route so it is used as a backup

B.

The administrative distance must be higher on the primary route so that the backup route becomes secondary.

C.

The floating static route must have a lower administrative distance than the primary route so it is used as a backup

D.

The default-information originate command must be configured for the route to be installed into the routing table

Correct Answer: A

Question No.63

Which result occurs when PortFast is enabled on an interface that is connected to another switch?

A.

Spanning tree may fail to detect a switching loop in the network that causes broadcast storms

B.

VTP is allowed to propagate VLAN configuration information from switch to switch automatically.

C.

Root port choice and spanning tree recalculation are accelerated when a switch link goes down

D.

After spanning tree converges PortFast shuts down any port that receives BPDUs.

Correct Answer: A

Question No.64

Refer to the exhibit. What does router R1 use as its OSPF router-ID?

image

A.

10.10.1.10

B.

10.10.10.20

C.

172.16.15.10

D.

192.168.0.1

Correct Answer: B

Question No.65

An engineer must configure a WLAN using the strongest encryption type for WPA2- PSK. Which cipher fulfills the configuration requirement?

A.

WEP

B.

RC4

C.

AES

D.

TKIP

Correct Answer: D

Question No.66

Refer to the exhibit. If OSPF is running on this network, how does Router 2 handle traffic from Site B to 10.10.13/25 at Site A?

image

A.

It sends packets out of interface Fa0/2 only.

B.

It sends packets out of interface Fa0/1 only.

C.

It cannot send packets to 10.10.13 128/25

D.

It load-balances traffic out of Fa0/1 and Fa0/2

image

Correct Answer: D

Question No.67

Refer to the exhibit. Which type of route does R1 use to reach host 10.10.13.10/32?

image

A.

floating static route

B.

host route

C.

default route

D.

network route

Correct Answer: D

Question No.68

A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

A.

port-to-multipoint

B.

broadcast

C.

point-to-point

D.

nonbroadcast

image

Correct Answer: C

Question No.69

DRAG DROP

Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.

image

Correct Answer:

image

Question No.70

Which 802.11 frame type is association response?

A.

management

B.

protected frame

C.

control

D.

action

Correct Answer: B

image

Get Full Version of 200-301 Dumps

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com