Get Full Version of the Exam
http://www.EnsurePass.com/200-150.html
Question No.111
When connecting a switch port to a virtualization host requiring 802.1q VLAN tagging, which spanning-tree port type should be configured on the switch?
-
normal
-
edge
-
edge trunk
-
PortFast
-
trunk
Correct Answer: C
Question No.112
Which two features must be licensed on a Cisco Nexus 5548UP Switch? (Choose two.)
-
Virtual Port Channel
-
Fibre Channel
-
FabricPath
-
iSCSI
Correct Answer: BC
Question No.113
Which two are Fibre Channel topologies? (Choose two.)
-
spine and leaf topology
-
port-to-port
-
port-to-multipoint
-
star topology
-
arbirated loop
Correct Answer: BD
Question No.114
What are two attributes of a VLAN? (Choose two.)
-
A VLAN defines a collision domain.
-
A VLAN defines a broadcast domain.
-
Broadcasts are flooded to all VLANs.
-
Collisions are flooded to all VLANs.
-
A Layer 3 device is required to route packets between VLANs.
-
A Layer 2 device is required to route packets between VLANs.
Correct Answer: BE
Explanation:
quot;In computer networking, a single layer-2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them via one or more routers; such a domain is referred to as a virtual local area network, virtual LAN or VLAN.quot;
quot;A router (Layer 3 device) serves as the backbone for network traffic going across different VLANs.quot;
http://en.wikipedia.org/wiki/Virtual_LAN
Question No.115
7K-3 and 7k-4 have the following configuration. Spanning-tree mst 1 priority 24576
Spanning-tree mst configuration name DCICN
revision 2
instance 1 vlan 100-150
Which of the following statements is true about the network?
-
7K-3 is the mst root for VLANs 100-150
-
7k-4 is the mst root for VLANs 100-150
-
Both 7k-3 and 7k-4 are the root for VLANs 100-150
-
MST is not enabled on 7k-3 and 7k-4
Correct Answer: D
Question No.116
What is the order of the OSI stack starting at Layer 1 and ending at Layer 7?
-
Application, Presentation, Session, Transport, Network, Data Link, Physical
-
Application, Presentation, Transport, Data Link, Session, Physical, Network
-
Physical, Network, Transport, Data Link, Session, Application, Presentation
-
Physical, Data Link, Network, Transport, Session, Presentation, Application
-
Presentation, Application, Data Link, Session, Network, Transport, Physical
Correct Answer: D
Question No.117
Which situation will cause a switch to flood traffic out all of the ports on the switch?
-
The switch receives a destination MAC address of 0000.0000.0000
-
The switch receives a destination MAC address of ffff.ffff.ffff
-
The switch receives a source MAC address of 0000.0000.0000
-
The switch#39;s TCAM reaches the MAC address limit.
-
The switch was configured in cut-through mode.
Correct Answer: B
Question No.118
What are two features of a bridge? (Choose two.)
-
Reliable transmission
-
Operate at OSI Layer 2
-
Operate at OSI Layer 3
-
Create multiple broadcast domains
-
Create multiple collision domains
-
Flood input packets to all ports
-
Drop IP packets with invalid destination ports
Correct Answer: BE
Explanation:
quot;- a bridge is a two interfaces device that creates 2 collision domains, since it forwards the traffic it receives from one interface only to the interface where the destination layer 2 device (based on his mac address) is connected to. A bridge is considered as an quot;intelligent hubquot; since it reads the destination mac address in order to forward the traffic only to the interface where it is connectedquot;
https://learningnetwork.cisco.com/thread/1734
Question No.119
Which layer of the OSI model is associated with the reliable transmission of datagrams?
-
Datagram
-
Routing
-
Network
-
Data link
-
Transport
-
Transmission
-
Session
Correct Answer: E
Explanation:
http://en.wikipedia.org/wiki/Transport_layer
Question No.120
Which block storage protocol can be used over unlimited distance?
-
SMB
-
iSCSI
-
Fibre Channel
-
FCoE
Correct Answer: B
Get Full Version of 200-150 Dumps